Version 1.0
©Copyright 2013, Ambient LLC. All Rights Reserved.
Page 8
2.
Plug the smart phone charging cable (Figure 2, reference 1) into the WR-099 power output
port.
Connect the appropriate smart phone tip (Figure 2, reference 2,3,4) into the other end of the
smart phone charging cable (Figure 2). Plug other end of the smart phone tip (Figure 2,
reference 2,3,4) into the smart phone’s charging connector.
3.
If the phone does not begin charging, begin cranking. When charging a smart phone via the
smart phone charger, it is important to turn the crank at least two revolutions per second, or
until you see red charging LED turn on. This is an indication that the phone is receiving
enough power from the WR-099. Continue to crank at this rate until you are satisfied that an
appropriate level of charge has been received by your smart phone.
NOTE:
You may receive a charging compatibility error on your smart phone, but your device may
still charge and it will not harm your device.
7.5
Audio Output / Head Phones
The WR-099 includes an audio output jack. This allows you to listen with headphones or connect to
an auxiliary input source, such as an amplifier.
CAUTION
: Guard your ears against hearing damage. When listening with headphones, start at the
lowest volume and gradually increase until you can hear it comfortably and clearly.
Read this Important Information before Using Your Earbuds:
Avoid extended play at very high volume as it may impair your hearing.
If you experience ringing in your ears, reduce the volume or shut off the unit.
Keep the volume at a reasonable level even if your headset is an open-air
type designed to allow you to hear outside sounds. Please note that
Excessively high volume may still block outside sounds.
7.6
Resetting the Unit
A protection circuit may engage if the WR-099 has an over current condition. Press the RESET
button (near the radio volume controls) to reset the protection circuit any time the unit appears dead.
Pressing reset will likely return the unit to normal operation.
8.
Care and Maintenance
8.1
Battery Maintenance
To maintain the battery and extend battery life, periodically charge through the USB power port every
few weeks. You can leave it plugged in all of the time and not damage the WR-099.
8.2 General Care and Maintenance
Do not tamper with the internal components of the unit.
Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors
CAUTION
: Never allow any water to enter the unit while cleaning.
