Amazone KG 6002-2, Оригинальное руководство по эксплуатации

Страница: 77 / 118

6.7.11 Adjusting the speed of the tines
6.7.11.1 Changing the gear on the manual transmission
REQUIREMENTS
The implement is cooled down
NOTE
The speed of the universal joint shaft must be set
to 1000 rpm. Lower universal joint shaft speeds
result in higher torques on the universal joint
shaft. This causes the ratchet clutches to wear
more rapidly.
Only use universal joint shaft speeds lower
than 1000 rpm under certain conditions.
Light sandy soils
Shallow soil tillage
If the ratchet clutch reacts too frequently,
immediately increase the universal joint shaft
speed to 1000 rpm.
1.
Depending on the set gear ratio
1
, selected
universal joint shaft speed
4
and the desired
tine speed
3
,
determine the desired gear
2
.
2 1 3
4
CMS-I-00003272
2.
To engage the first gear,
press the gear lever into the gearbox housing as
far as it will go
or
To engage the second gear,
pull the gear lever out of the gearbox housing as
far as it will go.
1
CMS-I-00003032
CMS-T-00004144-A.1
CMS-T-00004143-A.1
6 | Preparing the machine
Preparing the implement for operation
MG6750-EN-II | C.1 | 21.07.2021 71