Amazone E+S, Руководство по эксплуатации

Страница: 28 / 44

28
Putting into operation
DB 534 02. 02
7. Putting into operation
I
The max. angling of the PTO shaft cross
joint must not exceed 25°.
I
Always switch off the pto shaft in case
of too large angling or when it is not
used.
I
To avoid damage engage pto shaft or
hydraulic drive only at slow tractor
engine speed.
7.1 Filling the spreader
I
Before filling the hopper make sure that
no residue or foreign particles are in the
hopper.
I
Observe the permissible payload. Bear
in mind the specific bulk density [kg/l].
Depending on the condition of the
spreading material (moist or dry) other
specific weights may occur.
F
Before filling check the specific weight
of your spreading material. Weigh
accurately 1 litre spreading material. The
weight is the specific weight [kg/l].
a
Observe the maximum payload and
permissible axle loads and the
permissible total weight of the towing
vehicle. If necessary travel on public
roads with only half filled hopper.
a
Moving characteristics, steering and
braking ability are affected by mounted
implements, trailers or ballast weights.
Therefore, take account to these effects
and allow sufficient steering and
braking.
a
Therefore, when filling the spreader
observe that the required towing vehicle
front axle load is maintained (20 % of the
vehicle's empty weight, however, also
refer to the instruction manual of the
vehicle manufacturer).
I
To avoid a grinding of the spreading
material and thus an increased wear of
the agitator and the float hopper bottom
open the shutters wide enough so that
an unhindered flow of the spreading
material is ensured (especially important
with grit).
I
Spreading material which has frozen
over night may cause damage on the
agitating device when switching on the
spreading disc drive.