F R O N T & R E A R PA N E L
PAG E 4
VG A 4 4 I N S TA L L AT I O N & O P E R AT I O N M A N UA L
1
VGA44
4x4 VGA Matrix Switcher
2
REAR PANEL
3
4
1
2
OUTPUT
3
4
1
2
INPUT
FRONT PANEL
4
4
POWER ON SWITCH
This power switch turns the unit on and off. The
inbuilt LED will illuminate red to indicate that the
switcher is ON and is receiving power
SOURCE SELECT BUTTONS
A separate UP and DOWN source select button is
provided for each destination output. A 7 segment
LED display will indicate the input source number
assigned to a destination output. Any input source
can be assigned to any number of destination
outputs
IR SENSOR
The IR sensor receives IR commands from the sup-
plied remote control. To use the supplied remote
control, point the remote control at the IR sensor
RACk EARS
The VGA44 features rack ears for mounting within
a 19” Rack
1
2
3
3
1
2
3
4
SOURCE INPUT CONNECTORS
Four source inputs are provided, each featuring:
• One VGA video input on a 15 pin high
density D connector
DESTINATION OUTPUT CONNECTOR
Four destination outputs are provided, each
featuring:
• One VGA video output on a 15 pin high
density D connector
The selected input source is routed to the respec-
tive destination output.
RS232
Serial RS232 control port to allow for interfacing to
a PC, Crestron or similar third party control system
DC POWER INLET
The VGA44 VGA matrix switcher is fitted with a DC
power plug-pack input connector. Please ensure
that the plug-pack used is of an approved type and
is of sufficient current carrying capacity with the
correct voltage and connector polarity
1
2
3
4
4
VGA44 manual.indd 4
12/3/07 2:24:59 PM
