Amate Audio TPD, Руководство пользователя

Страница: 8 / 59

TPD Jul 2016
8
Amate Audio
Fig. 3.
Available loudspeaker connectors on the rear panel
Binding Posts: They accept direct cable connection up to 8mm
2
section (8AWG).
The Binding Posts are marked with Red for the Positive Pole, and Black for the
Negative Pole. Separate outputs are available for each channel: 2 binding Post
(RED/BLACK) for SW, 2 for L and 2 for R.
The outputs are configured as following:
Output SW L R
SPEAKON
Positive +1 (live) +1 (live) +1 (gnd)
Negative -1 (live) -1 (gnd) -1 (live)
Binding
Post
Positive RED RED RED
Negative BLACK BLACK BLACK
Table 2. Configuration of loudspeaker connections
WARNING: high risk of malfunction or major damage!
As specified in the previous point, there is the possibility to use
simultaneously the different outputs, such as SPEAKON and the Binding
Posts. Please make sure to check that the total load connected to each
channel is not below 4 Ohm, since all outputs are connected in parallel.
Be extremely careful when performing the connections, as a shortcircuit between any
of the
“live” pins (see
Table 2 ) can damage the amplifier or even cause the
destruction of one or both power modules.
4.3 Connection of the inputs/auxiliary outputs
The inputs and auxiliary outputs enable connection through XLR-3 connectors. The
amplifier incorporates balanced inputs for a high rejection of noise generated by long
signal cables, proximity to electric wires or sources causing them.
The auxiliary outputs enable the interconnection of other amplifiers to the
TPD
internal processor, which enables 3 independent processing channels.