Amano PE310AS, Руководство оператора

Страница: 16 / 32

16
Problem Possible Cause Solution
Battery plug is not connected Plug the battery plug to the machine.
Check for a loose battery connection.
Check batteries are wired together correctly via the battery connection diagram.
Battery voltage is too low Charge the battery using the appropriate charger.
Key switch failure Check key switch is functioning and wiring to the key switch is correct.
Failed Fuse Check the fuse.
Scrub switch off Turn on the scrub switch.
Scrub switch failure Check the scrub switch is functioning and wiring is correct. Replace if necessary.
Battery voltage is too low Charge the battery using the appropriate charger.
Carbon brushes are worn Check the carbon brushes, replace if necessary.
Bad wiring connection Check the wiring going to the motor for a bad or loose connection.
Vacuum switch off Turn on the vacuum switch.
Recovery tank full Empty and rinse the recovery tank.
Float valve is stuck Clean debris or dirt from the float valve.
Vacuum switch failure Check the vacuum switch is functioning and wiring is correct. Replace if necessary.
Battery voltage is too low Charge the battery using the appropriate charger.
Vacuum motor carbon brushes are worn Check the carbon brushes, replace if necessary.
Bad wiring connection Check the wiring going to the motor for a bad or loose connection.
Solution tank empty Fill solution tank.
Solution flow lever adjusted too low or off Lift up on the solution flow lever to increase flow.
Solution tank filter blocked/clogged Clean solution tank filter.
Solenoid stuck/plugged Clean solenoid.
Solenoid failure Check the solenoid is functioning and wiring is correct. Replace if necessary.
Solution vavle broken or out of adjustment Check valve and linkage.
Air leak Check recovery tank access lid; drain hose plug; recovery tank clean out.
Worn squeegee blades Rotate or replace squeegee blades.
Squeegee out of adjustment Adjust squeegee.
Vacuum hose blocked Flush and clean the vacuum hose.
Squeegee dirty / blocked Clean squeegee and remove any debris.
Vacuum motor filter clogged Clean vacuum motor filter.
Vacuum hose damaged / disconnected Reconnect vacuum hose to squeegee; replace hose if damaged.
Recovery tank full Empty and rinse the recovery tank.
Pad / brush worn down Replace pad / brush.
Using the wrong pad / cleaner Use chemical product and pad / brush recommended by an APEC distributor.
Pad pressure adjusted to low Increase pad pressure. (See
"Adjust Pad Pressure"
section)
Pad / brush is dirty Remove debris from pad / brush. Replace pad / brush if necessary.
Parking brake is engaged Disengage the parking brake
Traction breaker has tripped Reset traction breaker.
Using the traction motor with the parking brake engaged.
Check the drive assembly for damaged, loose, or missing parts.
Traction motor carbon brushes are worn Check the carbon brushes, replace if necessary.
Drive belt is broke / worn Replace drive belt.
Drive assembly is damaged Check the drive assembly for damaged, loose, or missing parts.
Bearings are worn Replace drive wheel bearings.
Using the wrong battery charger Use the correct 24V battery charger recommended by an APEC distributor.
Charger plugged incorrectly to machine Plug the charger to the battery "pigtail" cable.
Batterys are too weak / old Replace batteries.
Machine will not turn on
Pad Motor will not start
Vacuum motor does not
start
Incorrect battery connection
Machine will not move
forward
Traction breaker repeatedly tripps
Solution flow inadequate
or no solution flow
Machine trails water; has
poor or no water pickup
Machine exhibits poor
scrubbing performance
Battery will not charge
Machine Troubleshooting