Amano PE310AS, Руководство оператора

Страница: 12 / 32

12
Battery Charging
To charge the batteries, first drive the machine to a flat,
dry, well-ventilated area. Turn the machine off. Raise
the battery cover and leave open while the batteries are
charging. If using lead acid batteries, check the water
level in all the battery cells. If the level is low, add just
enough distilled water to cover the plates. **DO NOT
OVERFILL**
Only use the supplied or a battery charger approved by
Amano Pioneer Eclipse to charge the batteries. Using
the wrong charger can damage the batteries and void
any warranty.
WARNING! Batteries emit hydrogen gas when
charging. Explosion or fire can result. Keep
sparks and open flame away when charging.
CAUTION! Wear protective gloves and goggles
when handling batteries or battery cables. Avoid
contact with battery acid.
Unplug the battery cable from the machine plug at the
back of the machine and connect it to the charging cable
of the battery charger. Then plug the charger cord into
a wall socket. The battery charger will initialize and start
the charging cycle.
Note: DO NOT connect the charger to the
connector on the machine. This will not charge
the batteries and could damage the electrical
components of the machine.
When the charge cycle is complete, unplug the charger
from the wall socket. Disconnect the charger cable
from the battery connector. Reconnect the battery
cable to the machine plug, making sure there is a good
connection and it is pushed in completely.
Preparing the Machine
After charging, detach the battery charger plug from the
battery connector. Then connect the battery connector
plug to the machine plug. Close the battery cover. Turn
on the main key switch to operate the machine.
Filling Solution Tank
Before every scrubbing operation, remove the solution
tank fill cap and fill the solution tank with the right
quantity of water and cleaner. When filling the solution
tank, you can use the clear drain hose, at the back of
the machine, to see the fluid level in the tank.
For a proper cleaning of the floor, it is important to
choose the appropriate cleaner solution. Your Amano
Pioneer Eclipse Authorized Distributor can recommend
the appropriate Amano Pioneer Eclipse cleaner for your
particular needs. Please note that using a chemical
agent that is too-strong can compromise the long life
of your machine. It is important to use a low-sudsing
detergent solution, or an anti-foaming additive, in order
not to damage the vacuum motor.
Squeegee Adjustment
The squeegee must be properly adjusted in order to
dry the floor. For the best results, adjust the squeegee
until the rear blade contacts the floor with an angle of
approximately 45-60 degrees to the floor. Lower the
squeegee to the floor using the squeegee raise lever
and push the machine slightly forward. If the angle
needs to be adjusted, use the squeegee adjustment
knob to adjust the angle of the squeegee. Note that after
each adjustment, the machine must be pushed forward
in order to see the angle change.
If there is poor squeegee performance, check the
following:

Obstructions in the vacuum hose, inlets, filters, and
squeegee itself.

Vacuum motor operation.

All recovery tank inspection openings are closed.
How the Machine Works