Amano PE310AS, Руководство оператора

Страница: 15 / 32

15
Scheduled Maintenance
Daily Weekly Monthly
Every 6
Months
Annually
Empty and rinse the recovery tank

Check the vacuum motor filter

Check for loose or lost fasteners

Inspect hoses and connections

Inspect pad holder / brush

Check the squeegee blades

Check the suction hoses and squeegee

Inspect battery water level (Lead Acid only)

Thoroughly clean the recovery tank

Check the solution tank filter

Check wiring for fray or cut

Check the scrub deck linkage

Check the squeegee linkage and cable

Inspect drive belt

Replace drive belt
Check safety systems

Check the carbon brushes of motors

Check the electrical system

Check the brake system

Interval
As Required
These items must be performed with the proper tools and training. Contact an Amano Pioneer Eclipse
Factory Certified Technician unless you have the proper equipment and mechanical proficiency.
Operation
Vacuum Motor Maintenance
The vacuum motor must be checked and cleaned. The
carbon brushes should be checked every six months
and replaced if necessary. To check the vacuum
motor, remove the key from the main key switch and
disconnect the battery cable from the machine. At the
rear of the control panel, loosen the single screw (1) on
the bottom of the control panel. Raise the control panel
up, giving access to the vacuum motor.
Unhook the retaining strap (2) and disconnect the
cable plug (3) going to the motor. The motor can now
be removed for service and cleaning. While the motor
is removed, also thoroughly clean this area and the
foam filters (4) above and behind the motor. Replace if
necessary.
Remove, check, and clean the gasket (5) on the front of
the motor. Visually check the motor fan for damage and
make sure it is clean. Check the carbon brushes (6) by
removing the plastic cap and then remove the screws
that hold the plastic housings. If they are severely worn
or damaged, replace if necessary.
6
2
3
1
5
4
4