Amano MTX-15, Руководство по установке

Страница: 6 / 20

Page 4 MTX-15
Relay Circuits

Warning! All connections to the relay contacts must be Class 2
wiring with a maximum of 24 VDC, 1A.
Your MTX-15 is equipped with one relay NORMALLY OPEN (NO)
contact that can be used to control external equipment such as a bell or
buzzer. Connection to the contacts is via the screw terminal block on the
back panel PCB. The terminal block can be removed from the PCB to
facilitate wiring. The connections to the relay contacts must be Class 2
wiring with a maximum of 24 VDC, 1A.
Connections to the relay contacts are made as follows:
A typical wiring diagram for a bell circuit is shown below: