Amano MTX-15, Руководство по установке

Страница: 14 / 20

Page 12 MTX-15
Press the left Function key to return to the Diagnostic menu.
Reader Test
This test will display the type of reader installed in the MTX-15 terminal
and indicate the functional status of the reader.
Swipe a badge to initiate the test. If the display advances to the following
screen, the reader is functioning normally:
If “FAIL” is displayed instead of a number it indicates an unreadable
card.
The test can be repeated by re-swiping a card.
Press the left Function key to return to the Diagnostic menu.
Screen Test
This diagnostic tests the display by turning on all the pixels. Any spots
would indicate a defective pixel.
Press the left Function key to return to the Diagnostic menu.
Network Configuration
This selection will only function on an Ethernet Terminal and is used to
configure network communications.
Automatic IP is the default, which will obtain the settings automatically
when the terminal is connected to the network. If this is acceptable,
press the right Function key to save the setting and reboot the terminal.
“Please Wait” and “Rebooting” will flash along the bottom of the display
for a few minutes while the terminal reboots. The left Function key or
Esc
will exit without saving your setting or rebooting the terminal.