Amano MDK900-5-0-AC Series, Руководство по установке

Страница: 9 / 16

MDR300-0-0-AC-02 September 2010 Page 9
Configuring the Tag Frequency Mode
The Multi-discipline Readers offer three different Tag Frequency Modes. To select the
Tag Frequency Mode, do the following:
1. Power up the Reader. On power up, you have 5 seconds in which to set the Tag
Frequency Mode.
2. Present a Tag that matches your chosen Tag Frequency Mode:

Mode 1 (125 kHz): If you present a 125 kHz Tag for the full 5-second period,
the Reader will only read 125 kHz Tags.

Mode 2 (13.56 MHz): If you present a 13.56 MHz Tag for the full 5-second
period, the Reader will only read 13.56 MHz Tags.

Mode 3 (125 kHz and 13.56 MHz): If you present a 125 kHz Tag for 2
seconds followed by a 13.56 MHz Tag for 2 seconds, the Reader will read
both 125 kHz and 13.56 MHz Tags. This is the default mode.
NOTE: If you do not present a Tag within the 5-second period, the Reader uses the
last known Tag Frequency Mode.
Setting the Output Mode (OEM Use Only)
The Multi-discipline Readers offer four different Output Mode Combinations. Select the
Output Mode by doing the following:
1. On the back of the Multi-discipline Reader, locate and bridge the two stand-alone
Pins using the 2-Way Programming Pin supplied.
2. Power up the unit, the number of beeps indicates the selected Output Mode:

Mode 1 (1 Beep): 26-bit, HID Normal.

Mode 2 (2 Beeps): 44-bit, HID Normal (Default).

Mode 3 (3 Beeps): 26-bit, HID Raw.

Mode 4 (4 Beeps): 44-bit, HID Raw.
NOTE: The 26-bit and the 44-bit refer to the output format of EMM and Amano
Trinary Tags. HID Tags output in either normal or 45-bit raw mode.
3. Remove the 2-Way Programming Pins once the mode is selected.
4. Clip the Front Cover onto the Backing Plate.
Wiegand 44-bit Protocol
Tags are reported using Wiegand 44-bit Protocol.
An “EMM” Tag has an 8-bit User
Code and a 32-bit Serial Number.
These are reported as follows:

The 8-bit User Code is reported in bits 1 to 8 of the Protocol.

The 32-bit Serial Number is reported in bits 9 to 40 of the Protocol.

Bits 41 to 44 of the Protocol are the exclusive OR of the preceding 40 bits taken 4
at a time.