20
splattered, wipe with paper towel or clean with mild
detergent in warm water using soft sponge or cloth.
Wring sponge or cloth to remove excess water
before wiping unit. If desired, boil a cup of water in
microwave oven to loosen soil before cleaning:
•
Do not use cleaners containing ammonia.
These could damage finish.
•
Never pour water into microwave oven bottom.
•
Do not use water pressure type cleaning
systems.
Discharge Air Vents
There will be a slight buildup of cooking vapors
along discharge louvers in back of oven on right
side. Clean air vent with damp cloth and dry.
Oven Rack
Wipe with soft sponge or cloth dampened with mild,
sudsy water, or hand-wash in sink. Do not wash in
dishwasher or use abrasive cleaners.
antenna from getting dirty. Remove soil from shield
with damp cloth.
Remove splatter shield to clean more thoroughly. Be
careful not to bend antenna when removing splatter
shield. Unplug oven before removing to stop
antenna from rotating. Shield snaps into lip in front
of microwave oven and three slots in back. To
remove place thumbs into two indentations in front
of shield. Press lightly toward back and carefully
lower shield away from antenna. Pull shield
forward, out of back slots and out of microwave
oven. Wash shield in hot soapy water. Dry and
replace.
•
Do not wash in dishwasher.
•
Do not use abrasive cleaners.
When replacing, be careful not to bend antenna. To
replace, fit shield tabs into three slots at top of
back, lift front until shield snaps into place.
Temperature Probe
Wash in hot soapy water. Do not immerse probe
plug in water. Do not wash probe in dishwasher.
Dry thoroughly before using.
Important!
Wear gloves to protect hands
should bulb break. If hot, allow bulb to cool.
To change oven light:
1. Remove screw from and open cover on access
door on back of oven.
2. Remove bulb, being careful not to burn fingers
or break bulb.
3. Replace bulb with a 40 watt, 115-125 volt
appliance bulb available at grocery or hardware
stores.
4. Close access door and replace access screw.
5. Plug in microwave oven.
Mechanical
Oven Light
Caution
To avoid electrical shock hazard
unplug power cord or open circuit
breaker to microwave oven before
replacing light bulb. After replacing
light bulb, reconnect power.
Tools needed--
•
protective gloves
•
flat head screwdriver