Amano American Sanders American 8, Руководство оператора

Страница: 13 / 28

11
Sander Adjustment Procedures
DANGER: Electrocution could occur if maintenance and repairs are performed
on a unit that is not properly disconnected from the power source.
Disconnect the power supply before attempting any maintenance
or service.
DANGER: Moving parts of this machine can cause serious injury and/or
damage. Keep hands, feet and loose clothing away from all
moving parts of the sander.
Sanding Pressure
To adjust the sanding pressure follow this procedure:
1. Screw the sanding pressure knob down to increase the sanding pressure
when making the roughing in cut.
2. Screw the sanding pressure knob up to decrease the sanding pressure when
making the finishing cut.
Drum Rates
The machine can be operated at two rates. To change the speed of the drum,
follow this procedure:
1. Remove the belt cover.
2. Remove the fan belt.
3. Loosen the motor bolt.
4. Remove the hex nuts at the front of the motor.
5. Using the 5/32” Allen wrench, lower the motor locating screws.
6. Slide the motor forward.
7. For high drum rates, install drive belt in larger diameter of the grooves
available on the motor pulley and in the smaller diameter of the two grooves
available on the drum pulley. For lower rates, install drive belt in smaller
diameter of the grooves available on the motor pulley and in the larger
diameter of the two grooves available on the drum pulley.
8. Tighten belt and secure motor to chassis.
9. Install the fan belt.
10. Install the belt guard.