13
RS5320014 Rev. 0
Operating Instructions
Variable Time Entry
1. Open oven door and place food in oven. Display
shows “door”. Fan and light operate.
2. Close oven door. Display shows “MENU” and “ITEM”
flashes.
• If oven display does not show “ITEM”, pads do not
except entries. Open and close oven door or
press
STOP/RESET pad to activate pads.
3. Press
TIME ENTRY pad. Display shows “0000”.
4. Press number pads to enter desired cooking time.
5. Press
POWER LEVEL pad if power level other than
100 percent is required. Display shows “COOK
LEVEL” and current power level if other than 100
percent power.
6. Press number pad to enter desired power level. For
example, pressing
2 pad is 20 percent power.
7. Press
START pad and oven operates. Display shows
“POWER” when microwave energy is present. If
power level other than 100 percent power was
programmed, display shows “COOK LEVEL” and
power level. Display counts down cooking time.
8. Oven stops and signals when timing sequence is
finished. Display shows “EOC”.
9. Open oven door and remove food.
Summary of Variable Time Entry
1. Open oven door and place food in oven.
2. Close oven door.
3. Press
TIME ENTRY pad.
4. Enter desired cooking time. If 100 percent power is
desired, proceed to step 7.
5. Press
POWER LEVEL pad.
6. Enter desired power level.
7. Press
START pad.
8. At end of cycle, open oven door.
Changing Preset Number Pads
1. Open oven door. Display shows “door”.
• If door is closed or
RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press pad
1 for five seconds. After five seconds,
signal sounds. Display shows “P” and active menu.
3. Press
ADD pad.
4. Press desired menu pad. Display shows active
menu.
5. Press desired number pad. Display shows selected
number pad, “ITEM”, heating time, “COOK LEVEL”
and power level (if other than 100 percent power) for
stage one.
• If multiple stages exist, display shows “STG” and
number of programmed stages.
6. Press number pads to enter desired cooking time.
7. Press
POWER LEVEL pad if power level requires
change. Display shows “COOK LEVEL” and current
power level (if other than 100 percent power).
8. Press number pad to enter desired power level.
Display shows new power level (if other than 100
percent power). For example, pad
2 is 20 percent
power.
9. Press
START pad to enter new heating time and
power level in oven memory. Display shows “P”.
10.Press
RESET pad or close oven door to exit
programming mode.
Summary of Changing Preset Number Pads
1. Open oven door.
2. Press pad
1 for five seconds.
3. Press
ADD pad.
4. Press desired menu pad.
5. Press desired number pad.
6. Enter desired cooking time.
7. Press
POWER LEVEL pad if power level other than
100 percent is desired. Enter desired power level.
8. Press
START pad.
9. Press
RESET pad or close oven door.
