Amana Goodman RSKP0013, Руководство по установке, Страница: 3 / 20

3
O
RA
NG
E
BL
AC
K
RE
D
G
RE
EN
W
H
IT
E
YE
LL
O
W
BL
U
E
G
RE
EN
w
/Y
EL
LO
W
S
TR
IP
E
Remote Thermostat
*Only load wires needed for accessories attached to unit.
Figure 1
CONFIGURATION SETTINGS
The control can be configured to operate a wide range
of options. The options listed on the CONFIGURATION
SETTINGS chart with the * are the factory default settings.
If these are acceptable, then the unit does not require any
additional configuration and is fully operable. To configure
the unit, first select the configuration feature code setting
and then an option code to change from the factory default
setting.
To enter configuration feature mode:
1. Press and continue to hold the up and down arrow keys
and quickly press the OFF key twice within a two (2) second
time frame. The display will alternate between displaying the
feature code C1, for example, and the option code 0 (factory
default setting). The lower right dot on the display will flash.
To select a configuration feature code, press the HEAT
key until the desired configuration comes up. To scroll to a
previously viewed configuration codes press the COOL key.
Once you have scrolled to the correct feature, then to select
the option code for your desired configuration, press either
the up or down key to scroll through the options of the
selected feature code.
To exit configuration mode:
1. Press the OFF key. Configuration feature mode will also exit
if no keys are pressed for a period of two (2) minutes.
INITIAL BOARD PROGRAMMING
Press and continue to hold down the plus (+) and minus
(-) keys at the same time. While holding the keys down,
push the OFF button t wo (2) times, within a two (2)
second time frame. The display will show two (2) dash
lines and a flashing dot ( - - . ).
Release the plus (+) and minus (-) keys and press the
HEAT button three (3) times. The display will alternate
between C3 and O .
Press the plus (+) or minus (-) key until the display reads H
(for models PTH*) or C (for models PTC*). Please check
the serial plate of the PTAC to make sure you select the
correct code. Once H or C is selected, press the OFF key
to exit the programming.