February 1998
21
12074208
Ice Maker
Module, Motor, and Support Assembly
1.
Loosen both screws in module access ports.
2.
Disconnect shut-off arm.
3.
Pull mold from support assembly.
Remove module only by removing 3 screws and pulling
module out of housing.
Shut-Off Arm
1.
Pull shut-off arm out from white bushing.
2.
Replace by pushing completely in.
3.
Follow steps below.
Module and Heater Assembly
1.
Remove module and support assembly.
2.
Install module and support assembly on
replacement mold and heater assembly.
Fill Cup
1.
Remove module and support assembly.
2.
Remove ejector blades and shut-off arm.
3.
Pull fill cup from mold.
Module Ohmmeter Checks
No Power to Ice Maker and
Ejector Blades in End of Cycle Position
Test Points
Component
Module Position
Ohms
L - H
Mold and heater
Attached to support
264
L - M
Motor
Separated from heater
16,100
Module Voltage Checks with Meter or Test Light
Power to Ice Maker
Test Points
Component
Line Voltage
0 Volts
L - N
Module
Power on
Power off
T - H
Bimetal
Open
Closed
L - H
Heater
On
Off
L - M
Motor
On
Off
N - V
Water valve
On
Off
Disassembly Procedures
Cover
1.
Pull water adjustment knob forward.
2.
Snap off cover.
!
WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator using power switch before servicing.
Wires removed during disassembly must be
replaced on proper terminals to insure correct
earthing and polarization. After servicing,
reconnect power using power switch.
Shut off arm
Mold attachment screw
access ports
Adjustment
screw
