3.4. VERIFYING THE AMA3’S STATUS
You can ask your AMA3 for information anytime and anywhere.
Send the following message to the AMA3:
STATUS
The AMA3 will send you the following SMS:
AMA3 R5.01
PROG= 0,2,7,2,3
CONTACT: OFF
BAT=OK SIG=4
GPS=0/1
TIME:201446
DATE:010707
50:55:34 N
005:26:31 E
SPEED:0.00
OUTPUT OFF/ON
AMA3:
device type
R5.01
software revision
PROG= 0,2,7,2,3:
programming values (Function 1,2,3,4,5)
CONTACT: ON:
position of the ignition key
BAT= OK:
charge level of the vehicle battery (< 10,6 V = LOW)
SIG= 5:
strength of the GSM signal
GPS=0/1:
GPS signal (fix) (
1
= AMA3 has GPS signal,
0
= AMA3 has no signal)
TIME:201446:
time indication of the most recent GPS-coordinates (universal time)
DATE:010707:
date indication of the most recent GPS-coordinates
50:55:34 N:
GPS coordinates
005:26:31 E:
GPS coordinates (please enter the coordinates on
SPEED:0.00:
speed of the vehicle expressed in “knots”. (1 knot = 1,85 km/h)
SERVICE OFF:
service indicates the garage/service mode
OUTPUT ON:
Programmed output state (
if
enabled
!)
Attention:
The time and date are correct only when you receive GPS signal!
3.5. BATTERY FAULT (VEHICLE BATTERY)
The AMA3 will warn you if battery voltage is too low (< 10,6 V), if there is a disconnection of the battery
or the interruption of the power supply caused by, for example, a burned out fuse.
The AMA3 will send you the following SMS:
AMA3 R5.01
BATTERY FAULT
3.6. SWITCHING ON OR OFF THE RELAY INTERFACE
SWITCHING ON
This option is not activated. If you want to activate this option, you can’t use the buzzer function. To
ctivate see
2.3.4.
and choose value
0
.
(Fxxxx4=0)
Send the following message to the AMA3:
ONxxxx
xxxx
is the password. If you have changed your password please use your new one.
Do not enter any spaces before or in your message. After about 45 seconds the AMA3 will send an
SMS message as confirmation:
25
