AlzaPower APW-PS600, Руководство пользователя

Страница: 8 / 72

8 ENGLISH
Battery installation and replacement
The portable station comes with two replaceable batteries: APW-PSBP1 (1616 Wh) and APW-PSBP2
(2000 Wh). Follow these steps to install or replace the battery:
1. Open the lock and open the lid.
2. Hold the battery in both hands and carefully insert it vertically into the interior of the station. You
can insert the battery in both directions.
3. Close the lid and secure the lock. The portable station turns on automatically when the battery
is installed.
Note:
When replacing the battery, first remove the inserted battery and then insert a new one.
Charging the station
Only charge the station with the supplied charging adapter. Charge the station fully before use.
Input connectors intended for charging are:
• AC input port for charging from an AC outlet; super fast charging (max. power 1,200 W)
• XT60 input port for charging from the solar panel (solar panel not included); or
• input port DC5521 for charging e.g. from a car battery.
Note:
If you will not be using the station for a long time, we still recommend charging it regularly, at least
every 3 months. This will extend the life of the built-in battery.
Serial / parallel charging via solar panel
The portable station supports charging via a solar panel with a maximum output of 600 W.
The solar panel is not included in the package and must be purchased separately, including a con-
necting cable, which will be equipped with a terminal suitable for connection to the station. This is the
only way to achieve fast and efficient charging.
WARNING:
The maximum voltage of the solar panels that the portable station supports is 60 V and the maximum
current is 10 A.
Attention:
The portable station must be charged via a single solar panel with a voltage of less than 60 V. An input
voltage exceeding 60 V can seriously damage the station.
Each input connector of the XT60 serial input cable must be connected to the corresponding solar
panel before you can use it.
Charging the backup battery
You can charge the backup battery either by inserting it into the station, via an external charging
module (not included).
1. Press and hold the on / off button (for about 5 seconds) and the station will turn on. The number
of lit LEDs indicates the battery charge status.
2. The external charging module supports two charging methods - via a solar panel and via a car
battery. Connect the backup battery to the external charging module via the charging cable and
then connect the module to either the solar panel or the car battery.
3. The charge status LEDs will flash during charging. As the backup battery charges, the LEDs will
light up gradually. Once all 4 LEDs light up, the backup battery is fully charged.
4. When the station is on, the charge status indicator will still be on. Press and hold the on / off but-
ton and turn off the backup battery.
INSTRUCTIONS