4
2) Unscrew the fixing knob on the search coil and remove the knob connector. Place the
washers into the groove of the lower stem. Them insert the stem and align the holes on
the search coil bracket and the stem. Push the connector through the holes and tighten
the knob.
3) Press the silver button on the upper end of the lower stem, and slide the lower stem
into the upper stem. Adjust the stem to a length that you feel comfortable when you
stand upright with the detector in your hand, and the search coil is level with the ground
with your arm relaxed at your side. Then counter-clockwise rotate to tighten the lock
nut.
4) Wind the search coil cable around the stem. Insert the search coil cable plug into the
search coil jack on the detector control housing.
CAUTION:
•
The search coil’s plug fits into the connector only one way. Do not force the plug
or you could damage it.
•
Do not over tighten the search coil or use tools such as pliers to tighter it.
5) Stand and stretch your arm, holding the metal detector to make the search coil above
the ground for above 1 to 5 cm. Rotate the stem’s lock nut counter-clockwise to tighten
it.
Lower stem
Fixing knob
Washer
Search coil
Groove
Connector
Washer
Control box
Silver button
Lock nut
Fixing knob and
connector
Search coil