7
4) Control buttons
SENS
: Press SENS then + or – to increase or decrease the sensitivity. LCD will display the
current setting of sensitivity. If the target depth is beyond the max. sensitivity of the
detector, the target will not be found.
DISC numeric range (0
-
80)
:
Press DISC then + or – to select the desired DISC number. It
the target material is beyond the DISC range, it cannot be discriminated.
NOTE: The highest DICS number setting is 80. If you set the DISC number to 80, all target
less than this number will not be detected.
NOTCH
: Press NOTCH, then + or – to select the target to be notched. The cursor above
the selected target will flash. Press NOTCH again, the target name below the cursor will
disappear.
Operating
1. Turning on the detector
Rotate the VOLUME switch clockwise away from OFF to power on the detector. LCD will
display all symbols. Meanwhile the detector sounds low, medium, high tones
respectively. After about 2 seconds the detector enters into stand-by state. At this time
the default mode is DISC. LCD displays DISC of 00 and SENS of 6 bars.
2. Testing and using the detector
To learn how the detector reacts to different metals, you should test it before you use it
the first time. You can test the detector indoors and outdoors.
Indoor testing and use
1. Rotate the VOLUME switch clockwise away from OFF to power on the detector.
2. Setting the operating mode:
•
DISC: Press DISC, then + or – to set the DISC numeric value. If the DISC value is set
00, the detector can detector all metals. If you want one of the target material
listed on the LCD, you can set the relative numeric range of DISC by pressing DISC
then + or -. For example, the numeric range for 5 is 6-17, you can simply press
DISC, then set the DISC number to 7 or 10 by pr or -. If the detector finds
a coin of 5 , the cursor above 5 will light.
