Alvarion BreezeMAX PRO CPE, Руководство пользователя

Страница: 32 / 75

Chapter 2 - Installation
2.1.6 Connecting the Cables
2.1.6.1 Connecting the Grounding Cable
The Grounding screw (marked ╤ ) is located on the bottom panel of the outdoor
unit.
To connect the grounding cable:
1
Connect one end of a grounding cable to the grounding screw and tighten the
grounding screw firmly.
2
Connect the other end of the grounding cable to a good ground (earth)
connection.
2.1.6.2 Connecting the Antenna Cable
To connect the RF cable (units with external antenna):
1
Connect one end of the coaxial RF cable to the RF connector (marked )
located on the bottom panel of the unit.
2
Connect the other end of the RF cable to the antenna.
3
The RF connectors should be properly sealed to protect against rain and
moisture.
2.1.6.3 Connecting the SU’s IDU-ODU Cable
CAUTION
Use only Category 5E 4x2x24# FTP outdoor cables from an approved manufacturer. See list of
approved cables in Table
2-1 on page 13.
To connect the IDU-ODU cable:
1
Remove the two screws holding the waterproof service box to the outdoor unit
and remove the service box.
2
Unscrew the top nut from the service box.
3
Route a straight, uncrimped Category 5E Ethernet cable (8-wire, 24 AWG)
through both the top nut and the body of the service box.
4
Insert and crimp the RJ-45 connector. Refer to Appendix A for instructions on
preparing the cable.
5
Connect the Ethernet cable to the IDU COM RJ-45 connector.
BreezeMAX PRO CPE
16