Reset the expansion card
by pressing the
factory default switch until the expansion card’s
LEDs flash once (roughly 5 seconds). This is
normally never required.
Factory default the expansion card
by
pressing the factory default switch until the
expansion card’s LEDs flash twice (roughly 10
seconds). This is normally never required.
Cellular LED Indicators
are used to show the
state of the expansion card. The CS and Platform
LEDs are not used.
LED
Indication
Power
(Green)
ON and Flashing off once
every second
- Powered and
running
Cellular
(Red)
ON
- Registered with the local
cellular network
Signal Strength
can be determined using the
signal bar LEDs.
Signal Bar Cellular Signal Strength
0
Bad (0 to 14)
1
Marginal (15 to 19)
2
Acceptable (20 to 24)
3
Good (25 to 30)
4
Best (30+)
Factory Default Switch
Troubleshooting Cellular Expansion Card Problems:
• Ensure antenna connectors are securely snapped into the circuit board
•
Reposition the panel (move or rotate)
• Move the panel higher in the building
•
Move the panel away from metal objects (appliances, ducts)
• Move the panel closer to a window
• Move to a higher performance cellular antenna
Signal Bar LEDs
Cellular LED Indicators
