Alula RE114 Скачать руководство пользователя страница 12

Pro Tip

Pressing the test button

 on the smoke alarm will beep both the panel 

and smoke alarm.

Specifications

Physical 

Housing Dimensions
Weight with Batteries
Mounting Fastener

4.7 x 1.8 inches (12.0 x 4.6 centimeters)
7.36 ounces (210 grams)
#6 screws and anchors (provided)

Environmental

Operating Temperature
Maximum Humidity

40°F to 100°F  (4.4°C to 37.8°C), Long Term
15% to 95% non-condensing relative humidity

Sensor Specifications

Frequency
Replacement Batteries
Transmitted Indications
Loudness
Smoke Sensitivity
Heat Sensor

319.5 MHz
Two Panasonic® CR123A   
Low Battery, Supervision
85 dBA at 10 feet (3m) minimum
1.95% to 4% OBS/Foot
135 ± 5°F (57 ± 2°C)

Certification

RE114

FCC, IC, UL217, ULC531

Specifications subject to change without notice.

47-0023-01 • RevC • 2019-02-11

 Tech Support Line • (888) 88-ALULA • (888) 882-5852

alula.net

WARRANTY

Alula will replace non-portable products that are 

defective in their first five (5) years and all defective 

portable products in their first two (2) years.

IC NOTICE

This device complies with Industry Canada license-

exempt RSS standard(s). Operation is subject to the 

following two conditions:
(1) This device may not cause interference, and

(2) This device must accept any interference, including 

interference that may cause undesired operation of 

the device.

Le présent appareil est conforme aux cnr d’Industrie 

Canada applicables aux appareils radio exempts de 

licence. L’exploitation est autorisée aux deux conditions 

suivantes:
(1) L’appareil ne doit pas produire de brouillage, et

(2) L’utilisateur de l’appareil doit accepter tout 

brouillage radioélectrique subi, même si le 

brouillage est susceptible d’en compromettre le 

fonctionnement.

IC: 8310A-RE114

FCC NOTICE

This device complies with Part 15 of the FCC rules. 

Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.

(2) This device must accept any interference that may 

be received, including interference that may cause 

undesired operation.

Changes or modifications not expressly approved by 

Alula could void the user’s authority to operate this 

equipment.
FCC ID: U5X-RE114

TRADEMARKS

Alula is a trademark owned by Alula Holdings, LLC.

“Interlogix” is a trademark owned by United 

Technologies Electronic Controls Inc.
Alula products will function with Interlogix systems.  

However, no Alula product is produced by, endorsed 

by, or is officially associated with Interlogix. 

Alula recommends verifying proper enrollment and 

operation, per control panel installation instructions, at 

installation.
Panasonic is a registered trademark owned by 

Panasonic Corporation.

Содержание RE114













Отзывы: