Altronix Trove T1RSH3F8, Руководство по установке

Страница: 3 / 8

T1RSH3F8 - 3 -
Assembling and Attaching Z Bracket Wire Management Accessory
(included) - cont’d
:
5. Attach the hinge bracket on the longer side of Z Bracket to the adjustable rail using bolts and lock nuts (included) (Fig. 2, 2a, pg. 3).
6. Attach the hinge bracket on the shorter side of Z Bracket to the rear of the rack enclosure using bolts (included).
Installation Instructions for Trove1R:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local codes and authorities having
jurisdiction. Product is intended for indoor use only.
1. Remove backplane from enclosure prior to installing into rack cabinet (do not discard hardware).
2. In order to mount included UL Listed tamper switch (Altronix Model TS112 or equivalent)
turn the enclosure upside down. Punch out the knockout in designated location, on the back
of the unit, from outside of the drawer (Fig. 3, pg. 3). Insert the tamper switch into the
knockout from outside of the drawer with the button facing outwards and spaded connectors
inside the drawer. Connect tamper switch wiring to the Access Control Panel input or the
appropriate UL Listed reporting device. To activate alarm signal open the rack drawer.
3. Slide the rack enclosure into an open 2U location in the four post rack cabinet.
4. Utilizing proper fasteners attach front ears to the rack rails.
5. Attach the rear of the adjustable slides to the rear rails of the rack cabinet with the proper fasteners.
6. Ensure that all internal cofigurations (voltage selection, switch settings, etc.) are completed
before mounting backplane back into Trove rack enclosure.
7. Refer to the eFlow Power Supply/Charger Installation Guide for eFlow6NB and
corresponding sub-assembly Installation Guides for the following models:
ACMS8(CB), VR6 for further instructions.
ACMS8 Operations Instructions:
For more detailed information see ACMS8 Installation Guide, Rev. 090518 (included).
1. Set each output [OUT1] - [OUT8] to route power from power supply 1 or 2 (jumper position [+ PWR1 –],
[+ PWR2 –] or OFF) (Fig. 4, pg. 3). PWR1 = 24VDC; PWR2 = 12VDC.
2. Prior to connecting devices, ensure all output jumpers [OUT1] - [OUT8] are placed in the
proper positions (Fig. 4, pg. 3).
Note: Measure output voltage before connecting devices. This helps avoiding potential damage.
3. For connection options see ACMS8 Installation Guide, Rev. 090518.
Fig. 2
Fig. 2a
Fig. 3
Tamper Switch mounting location
Back of the drawer,
viewed from outside.
PWR1
PWR2
OFF
Fig. 4