28
Door Installation
6
Take the door to the greenhouse frame assembly
and slide it into place. Unlock and open the door
so that it is 90 degrees to the frame as shown in the
illustration on the opposite page.
You will need to pack the outside edge of the open
door, ideally with a wedge so you have some
adjustment or simply with some scrap cardboard
from the packaging. This will help you get the
frame in the correct position for fixing.
To start with you only need to put 4 fixings in the
frame, 1 on either side at the top and the same at
the bottom. The 50mm screws should go through
the same face that the strike plate is mounted on
and where the hinges are mounted on the other
side. The back of the frame should line up with the
inside face of the gable glazing bar, this should
then also mean that the glass rebate on the frame
header will line up with the rebate on the gable
glazing bars.
When you are happy with the position of the frame
fix it with the 50mm screws as shown on the
opposite page. This is only an initial fix and
adjustments can be made later.
Diagram 36
Diagram 37
Fix through
this face
Keep faces flush
EV0530
EV0532
EV0507
E
V
0
5
3
2
EV0608
Door Parts
Part Name
Part
Number
Qty
Door Lock
EV0606 1
4” Hinges
EV0607 3
Door Handle Set
EV0608 1
Single Door
EV0710 1
EV0710
External
External
Note: door opens
inwards
Eaves
bar
Содержание VICTORIAN OAKHAM
Страница 1: ...12 15...
Страница 26: ...26 5 Connect the next side as you did before Frame Assembly Finally attach the last gable section...
Страница 57: ...57 Finished installation 15...