LTO
LTO
TM
Phase:
The Sub (Subwoofer) channel provides fine control of the signal's phase, in 5 degree steps. When combined with
the 180 degrees polarity switch, it is possible to adjust the phase in the bass region through a full 360 degrees.
Freq:
The center frequency of each band can be set between 16Hz and 16,000Hz.
Band:
This dictates how the frequencies next to the center frequency will be affected during Gain boost or cut. With a
narrow bandwidth (minimum 0.05 octave), frequencies other than the center frequency and its immediate neighbours will
GRAPHIC EQUALIZATION (GEQ):
Each of the Front and Rear channels has a digital 10-band graphic equalizer. This type of equalizer has a fixed center
point and bandwidth. Gain is adjustable by +/- 15dB. The frequency centers are set at 31, 63, 125, 250, 500, 1000, 2000,
4000, 8000 & 16000Hz.
Use the "Ch Select" list to switch the display. An "ON/OFF" button allows instant comparisons of the sound with and
without equalization applied, while all frequency points can be set flat simply by clicking the "Reset" button.
4
4
Parameter Menus & System Set-up
IMPORTANT
IMPORTANT
Which filter type, slope and frequency you should choose will depend on the speakers you are using. Since
it is important to set-up filter points carefully to maximise speaker power handling and avoid damage, this
is usually best left to a professional car audio installer.
ADVANCED
ADVANCED
TIP
TIP
When making fine adjustments to signal phase in the bass region, bear in mind that phase is related to
frequency. You cannot "phase-align" the entire low-frequency band, but you can align the phase of two
woofers at 50Hz, for example, or whatever frequency you choose. Where dual woofers (one handled
through TOTAL RECALL, the other not) are causing cancellation because of different mounting positions
and/or mounting angles and/or vent characteristics, aligning their phase can substantially improve SPL
(sound pressure level) and clarity of bass.
PARAMETRIC EQUALIZATION (PEQ):
3-band full parametric equalization is provided on each of the channels. With this type of equalizer, frequency, gain and
bandwidth are all variable. In addition, TOTAL RECALL allows you to select from a list of different EQ contours.
5
5
Gain:
The level at the chosen center frequency can be increased or reduced by 15dB.
