MN-36580 (Rev. 2) 01/16 • Quickchillers • 26
settings
(
continued
)
Hold default - Touch
and enter default hold temperature between -5 to +40 (-21C to +4C) on number pad or select
factory default
.
defrost time - Touch
. This is the amount of time the defrost function will run before automatically switching
back to the chilling mode. Factory default setting is 20 minutes. Use
or
to adjust the duration of
defrost within a range of 10-30 minutes. The Quickchiller may not run for the entire length of time set,
but will move to drip cycle once appropriate coil temperature has been reached.
drip time - Touch
. This is the amount of time the drain heater will run after a hot-gas defrost function before
automatically switching back to the chilling mode. Factory default setting is 10 minutes. Use
or
to
adjust the drip time within a range of 5-15 minutes.
probes - Touch
to indicate the number of probes being used in the chiller (0, 1 or 3).
Factory settings - Touching
will reset all presets and user-defined settings to factory default settings.
Warning: pressing Factory reset will erase all User settings, recipes and presets programmed by
the user. note: Factory Settings cannot be reset when QC2 is in chill mode.
screen calibration - Touch
- and follow instructions to calibrate the touch screen. note: Screen cannot be
calibrated when QC2 is in chill mode.
alarm - Alarm will sound when product probe reaches the temperature set by the user. Touch
to
set alarm to off
, single beep
, or continuous beep
. Open door to end alarm.
demo mode - Touch
and enter code 6702 on number pad to cycle through control screens without
activating a chill cycle or changing the settings.
s u b t I t l e
t I t l e
o p e r a t I n g I n s t r u c t I o n s
o p e r a t I o n
