Altman Spectra-Strip Series, Инструкция по установке и эксплуатации

Страница: 4 / 12

I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L
4
Mounting the fixture
For floor mounting, the fixture includes a low profile integral floor trunnion at each end that allows for 180°
fixture swivel in either direction. The trunnions are designed in such a way to allow for multiple fixtures to be
placed as close together as possible for seamless use.
For pipe hanging, install a theatrical pipe clamp at each end. The pipe clamps mount directly in the center hole
of the foot of each integral floor trunnion. Use the two safety cables provided with the Spectra Strip when using
pipe clamps.
Connecting power to the fixture
Attach the blue PowerCON™ plug (included) into the fixture power input (blue). Plug the male Edison plug
into a properly grounded receptacle (100-240 VAC) connected to a circuit breaker. Feed thru PowerCON™
receptacles (gray) are provided at the opposite end of each Spectra Strip for powering neighboring Spectra
Strips. Up to 3 600W Spectra-strips maximum should daisy chain power in this fashion. All feed thru wiring
components are rated at 20 Amps.
Additional power thru cable assemblies are available from Altman lighting.
PowerCON® Cable Assemblies
PCL-PBG-12-5 5’ 20A PowerCON to Parallel Blade U Ground (Edison) Male (included)
PCL-TLG-12-5 5’ 20A PowerCON to Twist Locking Ground Connector Male.
PCL-2P&G-12-5 5’ 20 PowerCON to Stage Pin Male Connector
PCTJ-12-5 5’ 20A PowerCON to PowerCON Feed Thru Jumper
PCTJ-12-10 10’ 20A PowerCON to PowerCON Feed Thru Jumper
PCTJ-12-15 15’ 20A PowerCON to PowerCON Feed Thru Jumper
PCTJ-12-25 25’ 20A PowerCON to PowerCON Feed Thru Jumper
Connector Engagement
Connector Separation