MT306-501
User’s Guide
400-0637-001
4
6.
[FRST]
This command clears the card, restoring the factory default
settings.
Command Format: [FRSTCii]
Example:
To clear the card in slot 4, send [FRSTC4]. The card in slot 4
is now returned to its default factory values as shown below
from the cards status.
CONFIGURE: ON COMMAND
OUT RESOLUTION: NATIVE
HDCP IN: ON
HDCP OUT: FOLLOW
VC MODE: CONTINUOUS
DEFAULT TV IN: 1
CEC ON DELAY: 5 s
CEC ON TRYS: 3
GROUP: NONE
7.
[GROUP]
This command assigns a card to a group of cards. If a group
command is sent to the enclosure and the group number
matches, the group command is executed by all cards in the
group. The is no feedback with group commands and not all
cards or commands support group features.
Command Format: [GROUPxCii]
x
= Group ID (x = # from 1 to 8)
Example:
Assign the card in slot 4 to group 2 by sending [GROUP2C4].
Execute a group command by sending the command with a
group ID. For example, [ON1G4].
8.
[HWEN]
This command enables or disables the card hardware,
excluding the main microprocessor. Power to video and audio
circuitry is turned off. Use for saving power but to keep
response time short returning to normal operation.
This is not a group command.
Command Format: [HWENxCii]
x
= On/off (1 = on, 0 = off)
Example:
Disable the hardware to the card in slot 4 by sending the
following command:
[HWEN0C4]
9.
[MOD]
This command returns the card model number.
Command Format: [MODCii]
Example:
Read the model of the card in slot 4 by sending [MODC4];
feedback is similar to the following:
[MT306-501C04]
10.
[PRG]
This command puts the card into firmware update mode. Only
use when working with Altinex Technical Support.
Command Format: [PRGCii]
11.
[PWR]
This command returns the card power consumption in watts.
Command Format: [PWRCii]
Example:
Read the power consumption of the card in slot 4 by sending
[PWRC4]; feedback is similar to the following:
[2.69WC04]
12.
[PWRM]
This command is the same as the [PWR] command, but
returns power milliwatts.
Command Format: [PWRMCii]
Example:
Read the power consumption (in milliwatts) of the card in slot
4 by sending [PWRMC4]; feedback is like the following:
[2694mWC04]
13.
[SFT]
This command resets the card. It is the equivalent to powering
just the card off and on.
Command Format: [SFTCii]
Example:
Reset the card in slot by sending [SFTC4]. The card responds
with [RSTC04] indicating the card is resetting.
