7
DUAL/STEREO COMPRESSOR/NOISE GATE CN-220
Compressor/noise gate set up to 115 V.
Compressor/noise gate set up to 230 V.
Make sure that the fuse is the right one for the selected voltage:
FUSE (230V. 50-60 Hz)
FUSE (115V. 50-60 Hz)
T0,5A. T1A.
NOTE:
The fuseholder provide a place for spare fuse.
CAUTION:
Always make sure upon changing the fuse, that this is the adequate for the selected
mains voltage (T1A for 115V and T0,5A for 230V).
CONNECTING TO THE MAINS
The connection of the compressor/noise gate power supply to the mains takes
place by a standard cord included in the box.
Make sure that the unit power switch is at 0 position (turned off).
Insert the female I.E.C. connector of the tripolar cable into the unit power supply
male connector, placed at the rear panel.
Insert the male connector of the tripolar cable into the mains plug.
Turn on the unit power switch. In that moment the ACTIVITY LED
indicator (red or green)
of the noise gate section will light,
indicating that the unit
is turned on.
CAUTION:
Make sure that the mains voltage is the correct as well as their fuse is the adequate.
INPUT CONNECTION
The compressor/noise gate input signals is carried out through two XLR-3-31 female
connectors and two JACK ¼” wired internally in parallel mode, one per each channel. The input
connections are balanced, with a nominal impedance of 10 K
Ω
(5 K
Ω
unbalanced). The next list
shows the input pins correspondence as A.E.S recommendation practice: