Altai Technologies Ltd. All rights reserved
Altai C1n Super WiFi CPE Installation Guide
TPS13-002_rev1.0
2.
Wrap the C1n unit with a layer of rubber tape. Start from 1cm above of the lid.
Wrap a loop and overlap a half. Continue until it reaches the bottom. The
bottom should be completely shielded by the rubber tape.
Figure 2-9 Second Layer-Electrical Tape
3.
Wrap the C1n unit with a layer of electrical tape. Start from 1cm above the
rubber tape wrapping. Wrap a loop and overlap a half. Continue until it reaches
the bottom.
3.
Electrical Protection
3.1.
Grounding
It is essential for the equipments being grounded properly in order to prevent the C1n
from the electrical damage, and also to prevent the possible electric hazer due to
non-proper power grounding. Secure the grounding screw tight and the strip
connects to the ground.
The proper grounding design is required for all outdoor equipments. The poor
grounding design could cause the potential electrical damage.
We recommend that the Altai C1n Super WiFi should be installed with lightning rod to
avoid any potential electrical damage and to be connected with the ground node
to the existing ground. Proper grounding will always be the safety consideration for
the Altai C1n WiFi.
