Airfield Lighting Systems UK Limited
Aviation House, Russell Gardens, Wickford
Essex SS11 8BF Tel +44 1702 547866
www.alsukltd.co.uk
The letter indicates the light color of this window:
W-White, R-Red, Y-Yellow
The arrow indicates the toe-in direction of the main
beam (the figure on the right indicates toe-in left).
No arrow indicates no toe-in.
Installation Steps
1-12-in shallow base
2-light fixture
3-Ø10 lock-washers
4-M10×30 bolt
1. Carefully clean all contact surfaces of the light fixture and the base.
2. Put the O-ring gasket in the gasket track on the base.
3. Connect the connector(s) of the light fixture to the base supply cable(s). Check that
the A- and B-side are connected to corresponding circuit if two connectors are used.
4.
Place the connector under the light fixture and install in the base.
5.
For an installation on bases, use a torque limiting box spanner of 16/17 mm, install
and tighten the six fixing bolts or nuts to a torque value according to specification. For
other base manufacturers, refer to their specifications.
6.
After installation, make sure that each light fixture functions properly.
