23
Alpine TR42 Direct Vent Gas Fireplace
LOG INSTALLATION
Fig. 23– Bottom Twigs
Locate the bottom left twig (42-4) and position it onto the
left pair of locating pins with the burned face towards the
front. Next find the right bottom twig (42-5) and position it
onto the right pair of locating pins with the burned face
towards the front. (fig.23)
Fig. 24 – Ember Placement
Fig. 26 – Right Center Top Twig
Fig. 27– Center Top Twig
Fig. 28 – Left Top Twig
The ember placement is critical for the appearance of the
fireplace as it is burning but can also cause improper com-
bustion if not applied correctly. Take small dime sized
pieces of ember material and place it directly behind the
burner ports along the front of the burner. NOTE: DO NOT
COVER BURNER PORTS. You may cover the dead areas
on either side to hide the log pads and burner. (fig.24)
Fig. 25 – Right Top Twig
Locate the right top twig (42-6) and place its large end, flat
side down onto the pad of the right side log. Next place the
notch at the end of the log against the inside of the second
from the right grate iron. (fig. 25)
Locate the next top twig (42-7) and position it on the flat
spots on the right top twig (42-6) and the back log. (fig. 26)
Locate center twig (42-8) and place its large end into the
pad on the back log and place the notch against the center
grate iron holding the log in its place. (fig. 27)
Locate the left top twig (42-9) and place its single end
onto the pad on log (42-8) and its forked end over the bot-
tom left twig (42-4). (fig. 28)
Содержание TR42 - LP TAMARRON
Страница 2: ...2 Alpine TR42 Direct Vent Gas Fireplace ...
