4
-EN
Detaching the Front Panel
1
Press the PWR (power) button to turn off the
power.
2
Press the
(Release) button until the front
panel pops out.
3
Grasp the left side of the front panel and pull it
out.
NOTES
•
The front panel may become hot (especially the
connector terminals), this is not malfunction.
•
To protect the front panel, place it in the supplied
carrying case.
Attaching the Front Panel
1
First, insert the right side of the front panel into
the main unit. Align the groove on the front panel
with the projection on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no foreign
object between the front panel and the main unit.
•
Connectable to Remote Control Interface
Box (TDM-7577R/TDM-7576R only)
You can operate this unit from the vehicle's
control unit when an Alpine Remote Control
Interface Box (optional) is connected. For
details, contact your Alpine dealer.
Initial System Start-Up
1
When operating the unit for the first time after
installation or after the vehicle's battery has been
disconnected and reconnected, set the volume
level to its minimum, then remove the
detachable front panel. There is a small hole at
right side of the connector. Behind this hole the
red Reset switch is mounted. Press the Reset
switch with a ball-point pen or any other pointed
object.
Basic Operation
2
c
1
1
2
1
1
PWR / INTLZ
Reset Switch
MODE/LOUD
