Alpine PKG-RSE3DVD, Быстрый старт

Страница: 3 / 9

PRECAUTIONS
Product Cleaning
Use a soft dry cloth for periodi
c cleaning of the product.
For more severe stains, please
dampen the cloth with water
only. Anything else has the chance of dissolving the paint
or damaging the plastic.
Temperature
Do not operate your unit in ambient temperature above
+70°C (+158°F) or below -20°C (-4°F).
Moisture Condensation
You may notice the disc playback sound wavering due to
condensation. If this happens, remove the disc from the
player and wait about an hour for the moisture to evaporate.
Damaged Disc
Do not attempt to play cracked, warped, or damaged discs.
Playing a bad disc could severely damage the playback
mechanism.
Maintenance
If you have problems, do not attempt to repair the unit
yourself. Return it to your Alpine dealer or the nearest
Alpine Service Station for servicing.
Characteristics of LCD Panel
• After turning the system off, a slight ghost of the image
will remain temporarily. This is an effect peculiar to LCD
technology and is normal.
• Under cold temperature conditions, the screen may lose
contrast temporarily. After a short warm-up period, it will
return to normal.
• The LCD panel is manufactured using an extremely high
precision manufacturing technology. Its effective pixel
ratio is over 99.99%. This means that 0.01% of the pixels
could be either always ON or OFF.
Using Wireless Headphones
If ACC or the monitor’s power source is turned off, a loud
noise is produced through the headphones. Be sure to
remove the wireless headphones from your ears before you
turn the monitor off.
Never Attempt the Following
Do not grip or pull out the disc while it is being pulled back
into the player by the automatic reloading mechanism.
Do not attempt to insert a disc into the unit when the unit
power is off.
Inserting Discs
Your player accepts only one disc at a time for playback. Do
not attempt to load more than one disc.
Make sure the label side is facing up when you insert the
disc. Press to eject any disc that is inserted incorrectly.
Playing a disc while driving on a very bumpy road may
result in skips, but this will not scratch the disc or damage
the player.
New Discs
As a protective measure to prevent the disc from jamming,
press to eject any disc with irregular surface or inserted
incorrectly. When a new disc is inserted into the player and
ejected after initial loading, using your finger, feel around
the inside of the center hole and outside edge of the disc. If
you feel any small bumps or irregularities, this could inhibit
proper loading of the disc. To remove the bumps, rub the
inside edge of the hole and outside edge of the disc with
a ball-point pen or other such instrument, then insert the
disc again.
Center Hole
Bumps
Center Hole New
Disc
Outside
(Bumps)
Irregular Shaped Discs
Be sure to use round shaped discs only for this unit and
never use any special shaped discs.
Use of special shaped discs may cause damage to the
mechanism.
Correct Handling
Do not drop the disc while h
andling. Hold the disc so you
will not leave fingerprints on the surface. Do not affix tape,
paper, or gummed labels to the disc. Do not write on the
disc.
CORRECT
INCORRECT CORRECT