Alpine NVE-N077PS, Руководство по установке и подключению, Страница: 5 / 13

5
1
Check accessory parts.
×
3
×
2
2
Prepare tools and mounting information.
3
Park the vehicle in a safe and level location.
4
Apply the brake and remove the ignition key.
5
Mount the aerial on the roof.
Clean dust and oil at the mounting location and
mount the aerial.
Notes:
•
The magnet of the aerial is very strong. Proceed
cautiously to prevent any damage to the vehicle’s body.
Keep the magnet away from articles susceptible to
magnetic fields such as credit cards, watches, etc.
•
Do not paint the aerial. Reception sensitivity may be
decreased.
Screwdriver
Pencil and eraser
Spanner
Pliers
Electrical tape
Aerial
Aerial
1. Preparation
Power cables
13P RGB extension cable (6 m)
1
Bracket
5
Flanged self-tapping
screw (M5
×
15)
4
Hex bolt (M6
×
50)
3
Screw with double
washer (M5
×
8)
2
Floor base
One each for left and right
6
Spring
washer (M6)
7
Flanged hex
nut (M6)
8
Wing nut (M6)
9
Velcro
fastener
"
Self-tapping
screw (M3
×
12)
!
Velcro tape
×
4
×
4
×
4
×
2 ×
4
×
2
Battery (AAA)
Extension cables
Remote control
holder
Remote
control
Solderless
connector Parking brake
aux. cord Cable clamp Aerial
mounting plate GPS aerial
(5 m)
Mounting the aerial inside the vehicle.
1. Clean the mounting location.
2. Put on the aerial mounting plate.
3. Mount the aerial.
Notes:
•
Mount the aerial on a flat plane of the dash board or
rear tray.
•
Some thermal reflection type or thermal absorption
type glass may interrupt high frequency waves. If
reception is poor with the aerial installed inside the
car, try to mount the aerial outside the car.
×
2
×
4 ×
4
×
4
6
Routing the aerial cable.
1. Route the cable using the provided cable
clamps to take up the cable’s slack.
2. Use the waterproof pad when running the cable
under the vehicle’s rubber gasket.
3. Attach the cable at several points using the
remaining cable clamps.
Cable
clamp
Water
proof pad
(2.5 m) (4.5 m)