9
-EN
Accessory List
• Head unit ..................................................................................1
• Power cable...............................................................................1
• USB extension cable.................................................................1
• Microphone
*
.............................................................................1
• Mounting sleeve.......................................................................1
• Carrying case ............................................................................1
• Bracket key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Owner’s Manual..................................................................1 set
*
Only for CDE-148EBT.
Turning Power On and Off
Press
r
to turn on the unit.
Notes
• The unit can be turned on by pressing any other button except
y
.
•
V
SOURCE
key blinks each time the unit is powered on.
Press and hold
r
for at least 2 seconds to turn off the
unit.
Note
• The first time power is turned on, the volume will start from level 12.
Source Selection
Press
V
SOURCE
to change the source.
Tuner
Disc
USB/iPod
*1
BLUETOOTH Audio
*2/*5
vTuner
*3
Auxiliary
*4
Tuner
*1
Displayed only when the iPod/iPhone is connected.
*2
Displayed only when Bluetooth IN is set to ON, refer to “Setting
the BLUETOOTH Connection (Bluetooth IN)” on page 28.
*3
Displayed only when Alpine APP is set to USB, refer to “Setting
the communication mode with a smartphone (Alpine APP)” on
page 27.
*4
Displayed only when the AUX IN is set to ON, refer to “Setting
the AUX SETUP mode” on page 25.
*5
Only for CDE-148EBT.
Detaching and Attaching the Front Panel
1
Turn off the unit power.
2
Press
y
(OPEN)
to open the front panel (figure 1).
To close the front panel, press the left side until it locks as shown
in the figure 2.
3
Grasp the front panel firmly, slide to the left
, and then
pull
to remove.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
• Do not leave the front panel open, or drive the car with the panel open
as it may result in an accident or malfunction.
1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Getting Started
MUTE
/
/ENTER
AUDIO/SETUP
SOURCE
Rotary encoder
Detaching
Attaching
figure 1
figure 2
00ALPINE.book Page 9 Friday, January 11, 2013 10:01 AM
