Alpine CDA-7873R, Руководство пользователя

Страница: 15 / 44

13
-EN
Basic
→
Pattern1
→
Pattern2
→
Pattern3
→
Display OFF
Adjusting the built-in Crossover
You can change High Pass Filter, Low Pass Filter,
Phase on this unit, so that you can create your
favourite sound effects.
1
Press the X-OVER button repeatedly to select
the desired parameter.
2
Press the DN g or f UP button to select
the disired setting.
1. HPF (Setting the High Pass Filter):
→
OFF
←→
80Hz
←→
120Hz
←→
160Hz
←
Outputs all frequencies higher than that selected
according to your preference.
2. LPF (Setting the Low Pass Filter):
→
OFF
←→
80Hz
←→
120Hz
←→
160Hz
←
Outputs all frequencies lower than that selected
according to your preference.
(Only available when using the subwoofer output
from this unit.)
NOTES
•
If you turn the battery power OFF, all settings return
to factory default.
•
If HPF, LPF, Bass Control and Treble Control are all
set to ON, depending on the Bass Control and Treble
Control settings, you may not be able to reinforce the
sound effect.
•
Except when the HPF and LPF is turned OFF, the
subwoofer is in monaural mode.
•
When the subwoofer is set to OFF, LPF mode and
change of phase does not work.
•
If no buttons are pressed within 5 seconds, the display
for setup menu disappears while an ordinary menu
appears on the display.
→
OFF
→
HPF
→
LPF
Switching the Display Modes
CDA-7876RB/TDA-7588RB only
You can select the display pattern mode from
three display patterns. You can also deactivate the
display.
1
Press the DISP (DISPLAY) button to select the
desired Display pattern mode.
Each press changes the display patterns.
Changing the Audio Level Display
Pattern
CDA-7873R/TDA-7587R only
You can select the disired display pattern mode
from three Audio Level Display Patterns. You can
also deactivate the display.
1
Press DISP button to switch the display pattern.
→
Pattern 1
→
Pattern 2
→
Pattern 3
→
Display OFF