12
041-036-B000-001, Rev. A (07/2013)
2.4 Starting the Engine
• When starting the generator after adding fuel for the first time or after long term storage, or after running out of
fuel, turn the fuel valve to the ON position, then wait for 10 to 20 seconds before starting the engine.
•
Before starting the engine, disconnect any load from the AC receptacles.
NOTE:
1. Turn the fuel valve lever to the ON position. If the fuel tank was empty it may be necessary to pump the
primer bulb 7 times to get fuel to the carburetor.
2. Turn the engine switch ON.
3. Move the choke lever to the START position.
4. Pull the starter grip lightly until resistance is felt, then pull briskly out.
5. Move the choke lever to the RUNNING position after the engine warms up.
•
Do not allow the starter grip to snap back. Return it slowly by hand.
•
Do not let the starter rope rub against the generator body or the rope will wear out prematurely.
CAUTION!
Start
Running
Choke Lever
Engine Switch
Primer Bulb
Fuel Valve
2.0 Operation
Figure 2-3, Starting the Engine
