ACI Option
The AC indicator (green lamp) is located on the outside of the enclosure. When lit, it indicates
AC power is available at the power supply output and enables service personnel to determine
the status of the power supply without having to climb the pole.
Installation Procedure:
Remove the rear-most knockout (see Fig. 2-3).
1.
Feed ACI wires through the hole.
2.
Slide locking nut over the wires and thread onto lamp body
3.
(see Fig. 2-1).
Insert the crimped contacts into the plastic connectors. The BLACK wire must always go
4.
into the BLACK housing. Insert the remaining wire
(this may be white, yellow, or blue)
into
the WHITE housing (see Fig. 2-2)
.
Connect the shorter BLACK/WHITE set of wires to the BLACK/WHITE wires leading from
5.
the SPI. The remaining set of longer wires connects to the Output 1 connector on the
front of the XM2-300HP (Fig. 2-3).
Fig. 2-1, AC Indicator
Enclosure Wall
Fig. 2-2, Wire/Housing Assembly
Top View
White Housing
Black Housing
Black Wire
White, Yellow, or Blue Wire
Verify contact snaps
over metal retainer
Side View
2.0
Installation, continued
2.2 Installing the Optional AC Indicator (ACI) Lamp
Secure the contact. If you do not properly position the contact, overheating and cable assembly
failure can result.
CAUTION!
To remove the wire from the plastic connector, use a small screwdriver to depress the metal retainer and slide
out the wire.
NOTE:
To SPI
To Output
23
017-877-B1-001 Rev. A
Содержание XM2-300HP
Страница 1: ...XM2 300HP Technical Manual XM2 300HP XM2 300CE HP Effective September 2010 member of The Group ...
Страница 2: ...Power Alpha Technologies ...
Страница 62: ......
Страница 63: ......