Alpha AWS-125, Инструкция по эксплуатации, Страница: 11 / 32

11
2. Check items below when the GFCI goes OFF frequently.
• Force applied on the stone cutter.
• Water entered inside the stone cutter.
• Voltage drop due to sharing the same power source in work area.
• Worn carbon brushes
BEFORE USE
DANGER!
Before using the machine, check the following items. In particular, check items 1 to 5 before
plugging the power supply cord into the power outlet.
1. Check the working voltage.
– Be sure the voltage specifi ed on the nameplate is the voltage available at the
power outlet. If the machine is used with higher voltage than specifi ed, the
motor will burnout. Any attempts to do so may damage the tool and/or cause an
accident.
2. Make sure the ON/OFF switch is off.
– If you plug in the power supply cord without realizing that the switch is ON, the
machine will start and may cause an accident.
– Make sure the switch is in the OFF position before plugging the cord in the power
outlet.
3. Inspect the protective cover.
– Do not remove the cover. It will protect you if the saw blade breaks.
– Be sure to fi rmly attach the saw blade or any optional accessory.
4. Inspect the saw blade.
– Check if you have a specifi ed blade.
– Never use cracked, chipped, or any damaged blades.
– Follow the procedures specifi ed in the instruction manual to properly attach
applicable accessories.
5. Check the power outlet.
– When the plug of the power supply cord is easily pulled out of the power outlet,
the outlet should be replaced. For such tasks, consult an electrician. If the power
outlet is used on a continuous basis, it may overheat and cause accidents.
6. Perform test runs.