Alpha Telecom UTA120, Руководство пользователя

Страница: 14 / 55

Chapter 2: Software Installation and Configuration
UTA120 User’s Guide
6
CONFIGURATION
1. If you have just installed the UTA120 software, you will see the UTA120
window. Click on the “ UTA120 Configuration” icon. The Configuration
window appears.
+
If you have installed the setup software, but closed the UTA120 window, do the
following to open the Configuration window:
Ø
Click the Start button.
Ø
Highlight/select Programs.
Ø
Highlight/select UTA120.
Ø
Highlight/select and click on UTA120 Configuration.
2. Click the COM Port down arrow button to choose the port connected to the
UTA120.
3. In the section labeled Service Profile Identifiers - SPID, click inside the Tel
Port #1 window and enter a SPID. A SPID is the number that identifies each
terminal equipment to the Telephone Company. Notice that the SPID is
automatically copied to
Data Port #1.
+
Note: Your local phone company assigns SPIDs. Only the Data Port and the Tel Ports
can share SPIDs. The Tel Port or Data Port cannot share the same SPID with any S/T
devices.
4. In the section labeled Directory Numbers, click inside the Tel Port #1
window and enter the phone/directory number that corresponds to the Tel
Port #1 SPID window. Notice that the DN is automatically copied to Data
Port #1.
5. Repeat steps 2 and 3 for Tel Port #2 .
+
Note: You must enter a different SPID and Directory number than the SPID and
Directory number entered in Tel Port #1.
6. Speech/Fax/Modem (Tel Port #1 or Tel Port #2) :
+
If you choose Speech for either Tel Port, you can choose the Supplementary Services
function. If you choose Fax/Modem for either Tel Port, you cannot choose the
Supplementary Services function.
7. Data Call Protocol click the down arrow button to choose one of the
following:
Ø
HDLC Transparent (High-level Data Link Control) allows remote access
for the UTA120.
Ø
Asyn-to-Sync PPP (Asynchronous to Synchronous Point to Point
Protocol) allows 64Kbps or 128Kbps Internet access.