Page 16
AM-6000 Service Manual
Rev. A02
Side Mounting Bracket Removal
Next, you need to unfasten the AM-319-20 side mounting bracket from the deskside chassis. To do so:
1.
Remove the two Phillips head screws that secure the AM-319-20's side mounting bracket to the
chassis. Before you slide out the board and its mounting bracket, notice how the mounting
bracket is positioned over the two alignment tabs on the bottom of the chassis. When you
reinstall the assembly, you must make sure the mounting bracket is properly positioned over both
tabs; if it's not, it will be impossible to reinstall the two screws that hold the assembly in place.
POWER SUPPLY
1
2
3
4
5
6
AM-319-20 BOARD MOUNTING BRACKET
To remove the AM-319-20 board
mounting assembly, you must
remove these two screws.
Figure 13: Deskside Chassis - AM-319-20 Mounting Bracket Removal
2.
To remove the AM-319-20 and its mounting bracket, you need to lift the bracket high enough to
clear the bottom lip on the chassis. Once you clear the bottom lip, pull the entire assembly out
just far enough to disconnect the two DC power connectors that extend between the power
supply and the AM-319-20.