ALPATEC MG 13, Руководство пользователя

Страница: 10 / 24

English
10
- When the water tank (F) is empty, the « » indicator
light (1) will light up red.
• Turn off the appliance
• Fill the water tank (Fig. 1) with the aid of a funnel for
filling, while observing the maximum level (Fig. 2.
• Wait 3 minutes before running the appliance again.
- When the ice cube tray (J) is full, the « » (2)
indicator light will light up in blue and the appliance will
automatically come to a stop.
• Empty the ice cube tray by placing a container under
the spool XX(L).
• Hold down the ejector button (E). A blue light will light
up to indicate that it is in operation.
Caution: leave the container under the spool for a few
seconds after releasing the ejector button to allow the last
few processed cubes to fall inside the winder.
• Never leave the ice tray full while the appliance is in use.
Note: If the control viewer (I) is open, the ice cube spool
button (E) will not work.
- Once you are finished using it, press the start/stop
switch (6) to turn off the appliance.
- Disconnect the appliance from the mains.
- Drain and dry the water tank before storing the
appliance if you are not going to use it for an extended
period of time.
- To completely empty the water tank, open the drain plug
(C) under the water collection tray (B), ensuring that there
is a container underneath the appliance. When the tank is
empty, replace the plug (C).
Maintenance and cleaning
- Always disconnect the appliance before carrying out any
cleaning operation.
- Never clean the appliance while it is in operation, or use
abrasive products.
- Do not let water or any other liquid penetrate the
ventilation holes of the appliance, as this could lead to
damage.
- Do not immerse the appliance in water or other liquid
as this may damage the appliance and may present the
risk of accidents.
- In order to ensure optimum quality of the ice cubes, it is
recommended that you change the water every 24 hours.
Problems and repair
If the appliance does not work properly, please refer to
the following points before calling technical support:
Problem Possible causes Possible solutions
The «water tank empty»
indicator light lights up
The water tank is empty Switch off and disconnect the appliance to fill the water
tank
The «ice cube tray full»
indicator light lights up
The ice cube tray is full Empty the ice cube tray
The ice cubes are stuck
together
The manufacturing cycle is too long
The water tank temperature is too low
Stop the appliance and reconnect when the cubes have
melted. Select the «Small» size
Change the water in the tank, ensuring the temperature is
between 7 °C and 32ºC
There are ice cubes in the tray
but they do not come out when
pressing the spool button
The control viewer is open.
The ice cube spool button is blocked
Close the control viewer.
Release the spool button for 3 seconds and start the
process again
Despite having observed all
indications, no ice cubes are
being formed
The room temperature or the tempera-
ture of the water tank is too high
The coolant liquid is being lost, or the
cooling system pipe is blocked
-Do not use the appliance if the room temperature is
above 32 °C.
- Change the water in the tank, ensuring the temperature
is between 7 °C and 32ºC..
Stop the appliance, unplug it from the mains and contact
after sales service
If any of the proposed solutions do not work, do not attempt to disassemble the appliance yourself due
to the risk of accident, which would also void the warranty. Check with after sales service at the address
indicated in the warranty certificate or contact your dealer.