With an output screen selected, pushing and holding the program knob for just over 1 second
will access the extended output parameter selection.
Access ‘Extended’
Output Parameters
Push + Hold
Select Output
Twist
x1
1
Modifier
1
Shape
The various parameters can be cycled through and edited using the program knob just as when
editing output modifiers. To exit back up to the main output modifier screen, click and hold
the program knob again for just over 1 second.
Many output parameter values are in percentages of total ‘step time’. The step time is derived
from the selected trigger modifier. For example a divisor of /2 would have a step time of 2
beats, *4 would be a quarter of a beat.
Any output parameter value can also be assigned to be CV controlled via any of the available
CV inputs. See the Voltage control section for more info on this.
Certain parameters will only appear if a ’parent’ is enabled. Please see the Output Parameter
reference chapter below for info on each of the output parameters.
TIP:
The program knob hold time can be adjusted - see the SETTINGS chapter
8
