LEDS VISUALIZATION
DL1
(yellow led)
LIGHT (On) : DW24B in warning (contact Open)
DL2
(green led)
SWITCHED ON : power supply insert
SWITCHED OFF : lack of supply
DL3
( red led )
SWITCHED ON : pressed OPEN order
It remains lighted only during the time while it is pressed
DL4
( red led )
SWITCHED ON : presses CLOSE order
It remains lighted only during the time while it is pressed
DL5
( red led )
SWITCHED ON : pressed AP/CH order (Dynamic)
DL6
( red led )
SWITCHED ON : pressed PEDESTRIAN order
DL7
(yellow led )
SWITCHED ON : semi automatic cycle activated
SWITCHED OFF : automatic cycle activated
DL8
( yellow led )
SWITCHED ON : present LOW PHOTOCELL (Open contact)
DL9
( yellow led )
SWITCHED ON : present HIGH PHOTOCELL (Open contact)
DL10
( yellow led )
SWITCHED ON : present button of BLOCK (Open contact)
DL11
( red led )
SWITCHED ON : present END-RUN OF OPEN (Open contact)
DL12
(red led )
SWITCHED ON : present END-RUN OF CLOSE (Open contact)
Functionnement
Automatic Cycle:
Pressing N.O. button of Open the motor will begin to move for the time determinated
by the “End-run/working time” combination (P1).
The control works with normally closed End-run (N.C.).
With the gate opened the pause timer (It can be bypassed pressing the button of close) , after the deter-
minated time (P2), will close the door. If during the pause time an object or a person crosses the photo-
cell, it resets the the pause time which will start again from the beginning. We get same function, always
during the pause time, giving an opening impulse.
The contact of
Low and Hight Photocell
(N.C.) is activated only during the reclosing phase, it opens
again the door if there is an obstacle.
A possible temporary Block of the control can be obtained by acting on the block button (N.C.), in this
case the motor will stop until the open-close button will be pressed again giving movement to the gate in
the desired direction.
Pedestrian Function
: N.A. enter contact which operates the opening door for the time determinated by
the P3 trimmer.
During the reclosing phase the photocell or an impulse of Open will open the door completely.
Semiautomatic Cycle
(pass-pass):
All the functions are the same of the automatic cycle except the pause time that is not inserted, therefore
to reclose you should press the close button once again.
