Allot SG-9100, Руководство по оборудованию

Страница: 16 / 51

Chapter 2: Connectors and LEDs
Allot SG-9100 Hardware Guide 2-4
When removing a transceiver use the Fiber Cable Release Tool, located on the
rear panel of the unit. Slide the tool into the slot at the bottom of the transceiver
and slowly draw the unit out of the chassis.
Figure 2-5 – Fiber Cable Release Tool
LINK/ACT LEDs for each connection are located together to the left of the
interfaces.
NOTE 1G Copper interfaces may only use the 8 Port Bypass Unit,
limiting the number of ports which may be used on the SG-
9100 with Copper.
Ports should be connected from right to left on each card. For
example, on Card 1 L4 should be connected first, followed by
L3, L2 and finally L1.

M1 & M2 are two RJ-45 connectors (1G Copper) which may be used for system
monitoring and maintenance. M2 acts as a redundant port for M1.

Rear USB Ports should only be used to connect the SG-9100 to the Bypass unit
ONLY.

TSM Port is used to connect the TSM system to the Network. For more
information see Accessing the SG-9100 via the TSM on page 6-6.
CAUTION Each Rear USB connectors should ONLY be connected to a
single Allot Bypass Units. The bypass cable should only be
connected/disconnected when the system is powered down.
Power Supply
The SG-9100 contains two built in power supply modules and a dual line feed for
Redundancy purposes. Each line feed drives one power supply. It is possible for the unit
to operate normally with only one of the two power supplies active.