ALLNIC AUDIO 25th Anniversary T-2000, Руководство пользователя

Страница: 7 / 16

7
• DO consider using a high quality power cord, inter-connects and speaker cables. The T-2000 25 th
Anniversary is a highly sensitive piece of electronic designed for neutrality and will output what
you put into it. Allnic’s Zero Loss Technology cables will work synergistically with the T-2000 25
th
Anniversary .
•
DO try to place T-2000 25
th
Anniversary away from major sources and potential receivers of RFI
and EMI. Though well shielded, the T-2000 25
th
Anniversary will function best away from large
power transformers and other sources of such interference and from other equipment that could
be susceptible to/sources of such forms of interference.
B. INPUTS
There are four (4) RCA type female input pairs and one balanced (XLR) input pair. Facing the rear of the
chassis, the input connections are to the right of the IEC power input and the Pre Out terminal pair. The
left channel connector is the top one in each line input pair. Please refer to Figure 5.
You can use the T-2000 25 th Anniversary with a separate preamplifier by connecting the outputs of the
preamplifier to one pair of the T-2000 25 th Anniversary ’s inputs . HOWEVER, please use caution when you
do this. If you have both volume controls above zero on turn on, especially with signal, you could
damage your speakers because of the extreme volume level from the combined gain of both the
preamplifier and the T-2000 25th Anniversary . On initial turn on with a separate pre-amp, you should
have the volume on BOTH units set to zero. Then use the volume control on both the pre-amp and the T-
2000 25th Anniversary to set the volume control on the T-2000 25th Anniversary so that you can use
preamplifier volume control as the main volume control – OR vice versa, as you prefer.
C. PRE OUT CONNECTIONS
The T-2000 25 th Anniversary has a pair of RCA type female Pre Out (Preamplifier outputs – refer to Figure
5) connections on the rear of the chassis, between the IEC connection and the Line Inputs. The Pre Outs
are connected passively; therefore, when they are in use, the 6AK6, E282F and KT150 tubes continue to
draw power and operate. These connections are for use to connect to one or a pair of powered
subwoofers or, for bi-amping, to an external stereo power amplifier or pair of monoblock amplifiers
(preferably with the same gain as the T-2000 25 th Anniversary ).
D. SPEAKER TERMINALS
The T-2000 25 th Anniversary is equipped with two pairs of high-quality speaker terminals. These terminals
are located at the left of the back of the chassis (the right, facing the front of the chassis). Facing the front
of the chassis, the right channel pair is on the outside right and the left channel pair is to their left, on the
other side of the impedance toggle. The terminals accept bare wire (not recommended) and spade and
banana type connectors. Positive terminals are on top; negative below. Please refer to Figure 5.