Allnet ALL126AS3, Руководство пользователя

Страница: 13 / 262

ALL126AS3
USER’S MANUAL
12
2.5 Connecting the RJ-11 / RJ-45 Ports

The line port has 2 connectors: RJ-11 and terminal block. It is used to connect with NV-600L(CO) using a single pair phone
cable to ALL126AS3(CPE) bridge side (point to point solution). Take note that ALL126AS3 line port cannot be used at the same
time. Either RJ-11 port is connected or terminal block is connected using a straight connection ( Figure 2.4 ) or cross-over
connection( Figure 2.5 )

When inserting a RJ-11 plug, make sure the tab on the plug
clicks into position to ensure that it is properly seated.

Do not plug a RJ-11 phone jack connector into the Ethernet
port (RJ-45 port). This may damage the router. Instead, use
only twisted-pair cables with RJ-45 connectors that conform
to Ethernet standard.
Figure 2.1 ALL126AS3 line ports straight connection
Notes:
1. Be sure each twisted-pair cable (RJ-45 ethernet cable) does not exceed 100 meters (333 feet).
2.
We advise using Category 5~7 UTP/STP cables for Cable bridge or Router connections to avoid any confusion
or inconvenience in the future when you attached to high bandwidth devices.
3.
RJ-11 (VDSL2 Line port) use 24 ~ 26 gauge with twisted pair phone wiring, we do not recommend 28 gauge or
above.
4. Be sure phone wire has been installed before the ALL126AS3 boot.