Allmand ECLIPSE 2220/SE Series, Руководство оператора и каталог запасных частей

Страница: 6 / 41

6
The trailer should be properly set up with the jack stabilizers, sand bags, etc. in position before
leaving the
ALLMAND ECLIPSE 2220/SE SERIES deployed in the traffic control area. Periodi-
cally inspect the tongue, pins, safety chains, hitch, all nuts, bolts, cable clamps, wiring, etc. for
wear and repair or replace if necessary.
SAFETY NOTE/DISCLAIMER
ALLMAND BROS. INC. has taken precautions to ensure that the ALLMAND ECLIPSE
2220/SE SERIES is safe and reliable. ALLMAND BROS. INC. , however, is not responsible
for any injuries, accidents or other mishaps as a result of the use or misuse of this or any other
ALLMAND product. It is the user’s responsibility to ensure that the manner in which the
ALLMAND ECLIPSE 2220/SE SERIES is used is consistent with safe practices and the user
is to understand that he/she is the only liable party.
SET-UP/OPERATING INSTRUCTIONS
The following is a step-by-step procedure for set-up and operation of the ALLMAND ECLIPSE
2220/SE SERIES SOLAR ASSIST ARROWBOARD .
NOTE : Before transporting the trailer to the jobsite, be certain that the batteries are fully charged
using the optional ALLMAND ECLIPSE charger or any commercially available minimum 50
amp battery charger designed to charge a deep-cycle battery bank of this size. Be certain that
the battery bank is charged completely, allowing the unit to operate as long as possible before
low-voltage shutdown occurs.
1. Block the wheels of the trailer first, then remove the trailer from the towing vehicle.
2. With the sign panel directed toward the traffic, level unit off the tires using the jacks and /or
jackstands.
CAUTION : For safe operation and maximum visibility, sight through the eyelets midway up the
right frame uprights to align the unit relative to the roadway and the horizon as illustrated on the
following page. Observe the operation of the machine from varying vantage points down the
roadway to ensure that maximum visibility is maintained throughout the controlled area.
Lift the controller cover and turn mode switch to desired mode. Turn power switch on and deter-
mine that the display that has been selected is the desired mode and that it is operating properly.
CAUTION: Always check for overhead obstructions before raising sign panel.
3. Remove sign panel spring pins and erect sign panel by cranking braking winch. See WINCH
OPERATING INSTRUCTIONS on page 8.
4. Insert spring pins into the trailer uprights to stabilize the sign.
5. Ensure that the display is operating correctly and is readable from an adequate distance
before leaving the worksite.